Filter
Top Products
Page 16
The following items can be accessed through the interior
of the ramp by removing either the top or bottom cover.
Bottom Cover: The snap-on bottom cover can be
removed for easy access. The bottom cover is easily
removed via two draw latches on each side (see Photo
P), along with four bolts across the front (see Photo O).
When replacing, make sure to install a new tie wrap on
the latches in order to secure the bottom cover. Inspect
the bottom cover seals and replace when necessary.
Top Cover: Only remove the top cover when deemed
absolutely necessary to obtain access to specific parts
not available via the bottom cover. Remove the ramp
mounting hardware and lower the ramp assembly in
order to remove the top cover. Replace the double sided
foam tape seal whenever the top cover is removed.
Cleaning and Lubrication: All interior parts
of the ramp, accessible via the top or bottom
cover, may be cleaned with high pressure
air only. Use a cleansing cloth to wipe away
debris deposits and large buildups.
Ensure guide rails are clean and free of all
debris. Carriage track rollers are sealed and
do not require lubrication.
Note: Ramp controller includes an Ob-
struction Sensing Feature. Debris build
up or obstructions (rocks, sand, dirt) in the
guide rails can result in the ramp stopping
or reversing direction during in-out functions
(if obstructed). Again, ensure the guide rails
are clean.
Interior Maintenance and Lubrication
Draw Latch
Bolts Securing
Front Cover
Tie Wrap
Maintenance, Lubrication & Adjustments
Photo O Photo P