Filter
Top Products
Page 15
Front Cover Ramp Toe
Maximum Setting
Toe of Ramp
Contacts Cover
2. When decreasing the height, the non-used
portion of the threaded studs must be cut off
to maintain proper clearance for main axle
rotation (see Photo N). Failure to do so may
result in the inability of the platform to lower
to stow level due to a binding condition of the
main axle, possibly causing damage to the
elevation motor.
Cut off excess threads.
Floor Height: Variable height adjustments are
made by screwing the four threaded bar ramp
supports in/out to achieve the desired floor level
height. Once initially set during installation, this
height should not require altering. Two items to
note.
1. When increasing the height, the maximum
is achieved when the ramp toe contacts the
inside of the front cover (see Photo M). If the
maximum is surpassed, the front cover will
remain partially open when the ramp is in the
fully stowed position, thus allowing foreign
material and debris to enter the cassette.
Lift ramp to access bolts.
Maintenance, Lubrication & Adjustments
Photo L
Photo NPhoto M
Exterior Adjustments (continued)