Filter
Top Products
Page 14
Ramp Skid Pad Guide Rail Slide Tube Ramp Skid Pad Contacting Top of Guide Rail
2 MM
2 MM
Floor Level Sensor Stow Level Sensor
1. The floor level (up) sensor pick-up (see Photo
H) should be adjusted (via the set screw)
so that the elevation motor stops once the
platform has gently touched against the
top cover lip (see Photo G on page 13 ), or
vehicle threshold if further from the center of
the vehicle. Incorrect setting of this pick-
up could result in a large gap between the
platform and the threshold (too low) or in the
ramp retracting into the stowed position due
to obstruction sensing (too high).
2. The stow level (down) sensor pick-up (see Photo
I) should be set (via the set screw) to allow a
smooth transition of the ramp platform into the
cassette. Ramp skid pads, located on the back
corners of the ramp (see Photo J), reduce friction
at the point where the ramp corners contact the
top of the guide rail. See Photo K. Carefully ob-
serve the ramp skid pads when adjusting the stow
level sensor pick-up. Note: An incorrect setting
of the stow level could result in excessive wear,
premature failure, or the shearing off of the ramp
skid pads (pads are replaceable).
Set ScrewFloor Level Pick-Up Set ScrewStow Level Pick-Up
Maintenance, Lubrication & Adjustments
Photo H Photo I
Photo J Photo K
Exterior Adjustments (continued)