Filter
Top Products
8
The following chart shows the commands in the Voltage function menu. Some
commands may not appear on all models. Menus are circular, you can return to the
starting position by continuously pressing p or q.
Key Display Command Function
VOLT <value> Set immediate rms output voltage
VOLT:T <value> Set triggered rms output voltage
VOLT:M FIXED Select the voltage mode
OFFSET <value> Set immediate dc offset voltage
OFFSET:T<value> Set triggered dc offset voltage
OFFSET:M FIXED Select the dc offset voltage mode
RANGE 150 Selects the voltage range
SLEW <value> Set immediate voltage slew rate in volts/second
SLEW:T<value> Set triggered voltage slew rate in volts/second
SLEW:M FIXED Select the voltage slew mode
ALC INT Select the voltage sense source
ALC:DET RMS Select the voltage sense detector
From the Entry key group
Use these keys to increment/decrement or select the command parameters to be
executed. If the parameter is a number, use these keys to make minor changes to the
value. Enter enters the selection and returns to the Meter function.
-
321
0
.
789
4
56
ENTRY
E
Calibration
Enter
Clear Entry
Key Display Description
, ,
VOLT:M FIXED Sets fixed mode
VOLT:M STEP Sets step mode
VOLT:M PULSE Sets pulse mode
VOLT:M LIST Sets list mode
to
Use the numeric Entry keys to directly enter a value for the command parameter. For
example, to enter a value for the voltage parameter:
Key Display Description
VOLT 0 0 volts
,
VOLT 60 60 volts
60 V 60 Hz enters the value and returns to the Meter
function
Voltage
Voltage
9
Voltage
6
0
Enter
1