Filter
Top Products
HV-WP/HW-WP Series Page 29
11. Upper/Lower Comparator Function
Function table Meaning and purpose
A
f6 7
When the display value becomes stable and not nearly-zero, the
scale compares the value.
A
A
Caution
The upper limit value (HI) must be greater than the lower limit value (LO).
The parameters of the upper limit value (HI) and the final value (HI) use the
same memory. The parameters of the lower limit value (LO) and the zero band
(LO) use the same memory.
The upper/lower comparator function, the simple batch function and the
full/dribble batch function can not be used at the same time because these
parameters use common memory.
11.1.
11.1.11.1.
11.1. Preparation (Setting Parameters)
Preparation (Setting Parameters)Preparation (Setting Parameters)
Preparation (Setting Parameters)
Step 1 Turn off the display.
Press the
ON/OFF switch while the ZERO switch is
pressed and held. The function table is displayed.
Step 2 Press the ENTER switch to display an item of the
accumulation function ( f6 ).
Step 3 Select a parameter of the comparator function
( f6 0 ~ f6 7 ) with the ∧ switch.
Step 4 Press the ENTER switch to store the new parameter.
Step 5 Press the F switch and the ENTER switch to exit from
the function table. Then the scale displays the
weighing mode.