A&D HV-60KV-WP Scale User Manual


 
HV-WP/HW-WP Series Page 17
7. Basic Operation
7.2.
7.2.7.2.
7.2. Tare (And Net Display)
Tare (And Net Display)Tare (And Net Display)
Tare (And Net Display)
"Tare" is used to cancel the mass of a container, receptacle, case, bag, etc. which is
put on the weighing pan to contain the item to be weighed.
Caution
Using a tare value reduces the weighing range.
The current tare value is reset by pressing the ZERO switch or turning the
scale off. (Reset value is zero.)
The preset tare value must be within the minimum weighing range for the
HV-WP series.
7.2.1.
7.2.1.7.2.1.
7.2.1. The Way of Tare Input by Weighing
The Way of Tare Input by WeighingThe Way of Tare Input by Weighing
The Way of Tare Input by Weighing
Step 1 Put the container item on the weighing pan.
Step 2 Press the TARE switch. The display becomes zero and the net mark is displayed.
Step 3 It is now possible to put something into the container and to read its net display.
Step 4 Remove all things on the weighing pan.
7.2.2.
7.2.2.7.2.2.
7.2.2. The Way of Digital Input (Preset Tare)
The Way of Digital Input (Preset Tare)The Way of Digital Input (Preset Tare)
The Way of Digital Input (Preset Tare)
Step 1 Press and hold the SET switch and press the TARE switch.
Then the blank or stored tare value is displayed. A blank display means that the
tare value is zero (reset value), and or blinks.
Step 2 Set the preset tare value by using the following switches.
switch Selecting the number of the figure.
switch Selecting a figure.
F switch Selecting the polarity (+,-).
Step 3 Press the ENTER switch to store the new preset tare value.
Then the scale displays a net value with the tare value subtracted from the gross
weighing value.
Step 4 It is then possible to put something into the container and to read its net.
Step 5 Remove all things from the weighing pan.