Filter
Top Products
HW-G Instruction Manual Page 63
HW-G OZIM v1a
Installation of OP-06
Caution
This option cannot be used with type L (Liquid Crystal Display) scales.
Packed with the option OP-06 are the following items which are used to install the
printer into your scale.
Reference No. Description Quantity
6 Printer cover 1
7 Printer unit 1
8 Printer control board 1
a Self tapping screw 3
b Screw with washer 4
Paper roll (PP-156) 1
Spare ink ribbon (ERC-05) 1
Installation Method
1. Disassembly
a) Disconnect the scale power plug from the
AC mains supply socket.
b) Loosen the lock screws and remove the
rear cover unit (Item 3)
c) Loosen 4 x screws (Item c) and remove
the upper case unit.
d) Remove 2 screws (Item a) and remove
the Battery Cover.
2. Installation
(a) Connect CN2, of the printer board (Item 8),
to J5 on the main board (Item 1)
(b) Install the printer board (Item 8) to the
4 stand-offs on the board on the upper
case (Item 1).
(c) Secure the printer unit (Item 7) to the
upper case (Item 1).
(d) Connect the printer unit cable to CN4
on the printer board (Item 8).