Filter
Top Products
HW-G Instruction Manual Page 60
HW-G OZIM v1a
Zero
The current mass value is set to the zero point, this is same as the
ZERO
switch.
Template Z
Command
Reply
The mass value becomes zero and zero point mark is displayed.
Tare
The current mass value becomes zero after placing a tare (receptacle, case, etc)
and the net is displayed. This is same as the
TARE
switch
.
Template T
Command
Reply
The current mass value becomes zero and net mark is displayed.
Cancel of tare
The display value becomes the gross and the net mark is turned off. (The tare value
becomes zero.)
Template CT
Command
Reply
Gross is displayed and the net mark is turned off.
Preset tare
The tare value is set and the net is displayed. The net mark is displayed.
Template PT,[parameter]
Command
Reply
Net is displayed.
Upper limit value
An upper limit value is stored.
Template HI,[parameter]
Command
Reply
The upper limit value is stored.
Lower limit value
A lower limit value is stored.
Template LO, [parameter]
Command
Reply
The lower limit value is stored.
Caution The lower limit value must be less than the upper limit value.