Filter
Top Products
HW-G Instruction Manual Page 35
HW-G OZIM v1a
Step 8 Press the MODE switch to display the HI,
flashing, (of the final value).
Step 9 Set the final value using the following
switches:-
^ switch Selecting the value of a digit.
< switch Selecting a digit.
Step 10 Press the ENTER switch to store the new
parameter and display the blinking OK
(of preliminary value).
Step11 Set the preliminary value using the following
switches.
^ switch Selecting the value of a digit.
< switch Selecting a digit.
Step12 Press the ENTER switch to store the new
parameter and display the blinking LO
(of zero band).
Step13 Set a zero band which is greater than the
tare value, using the following switches.
^ switch Selecting the value of a digit.
< switch Selecting a digit.
Step14 Press the ENTER switch to store the new
parameter and display the weighing mode.