28
Getting Started
2
Using the Battery
Use only a rechargeable lithium-ion D-LI90 battery.
Note:AC plug cord “Listed, Type SPT-2 or NISPT-2, 18/2
flexible cord, rated 125V, 7A, minimum 6ft (1.8m)”
1 Connect the AC plug cord to the charger.
2 Plug the AC plug cord into the power outlet.
3 Face the 2 mark on the battery up and insert it
into the battery charger.
The indicator lamp turns on during charging and turns off when the
battery is fully charged.
4 Remove the battery from the battery charger.
Caution
• Do not use the provided battery charger to charge batteries other
than battery D-LI90. Charging other batteries may cause damage
or overheating.
• If the battery is correctly oriented and inserted into the battery
charger but the indicator lamp is not lit, the battery is faulty. Use a
new battery in the camera.
Memo
• The maximum charging time is approximately 390 minutes.
Charge in a location where the temperature is between 0°C and
40°C.
• If usage time is reduced, the battery has reached the end of its
usage span. Use a new battery in the camera.
Caution
• Do not open the battery cover or remove the battery while the
power is on.
• Remove the battery when you will not use the camera for a long
while. Otherwise, the battery may leak.
• If the battery is removed for a long while, the date and time settings
may be reset.
1 Open the battery cover.
Lift the battery cover unlock knob, turn
towards OPEN (1) to unlock, and
then pull the cover open (2).
Charging the Battery
Lithium-ion battery
Battery charger
Indicator lamp
AC plug cord
Inserting/Removing the Battery
