Multiple Network Address Translation 3-21
Binding Map Lists and Server Lists
Once you have created your map lists and server lists, for most Netopia Router models you must bind them to
a profile, either a Connection Profile or the Default Profile. You do this in one of the following screens:
• the IP profile parameters screen (see below) of the Connection Profile configuration menu
• the IP Parameters (WAN Default Profile) screen (see page 3-23) of the Default Profile configuration menu
• the Binding Map Lists and Ser
ver Lists screen (see page 3-21)
IP profile parameters
To bind a map list to a Connection Profile, from the Main Menu go to the WAN Configuration screen then the
Display/Change Connection Profile screen. From the pop-up menu list of your Connection Profiles, choose the
one you want to bind your map list to. Select IP Profile Parameters and press Return.
The IP Profile Parameters screen appears.
• Select NAT Map List and press Return. A pop-up menu displays a list of your defined map lists.
Main
Menu
WAN
Configuration
IP Profile
Parameters
Display/Change
Connection Profile
IP Profile Parameters
Address Translation Enabled: Yes
IP Addressing... Unnumbered
NAT Map List... Easy-PAT List
NAT Server List... Easy-Servers
Local WAN IP Address: 206.1.1.6
Local WAN IP Mask: 0.0.0.0
Remote IP Address: 127.0.0.2
Remote IP Mask: 255.255.255.255
Filter Set... Basic Firewall
Remove Filter Set
RIP Profile Options...
Configure IP requirements for a remote network connection here.
