3G WiFi Router User Guide YML-O-3G19W
16 www.netcomm.com.au
4. 3G Settings
Select your 3G Mobile Broadband service settings according to predened or custom proles. Setup instructions are provided in the
following sections for your assistance.
This menu includes 3G Mobile Broadband service Setup, Network Selection and PIN Conguration.
4.1 Setup
NOTE: Sections 8.3 and 8.4.2 also provide information about the 3G Mobile Broadband service.
Your Service Provider will provide the information required to complete the rst time setup instructions below. This includes prole,
username and password. Only complete those steps for which you have information and skip the others.
1. If your SIM card is not inserted into the Router, then do so now.
2. Type the APN in the APN eld. Authentication Method should be provided by your Internet service provider; or just leave it set to
AUTO if not required. If you have not received a username and password, leave these elds empty.
Select IP compression and Data compression to be ON or OFF. By default they are set to off.
3. Click the Save button to save the new settings.
4. Press the Connect button to reboot the router and to connect to Internet. After reboot, the Device Info for
The 3G network box in the WUI Basic screen should indicate an active connection, as shown below. The 3G and Internet LEDs on the
front panel of the Router should also be blinking.
If the LEDs are off, then either your prole settings are incorrect, the SIM card is not working or the service network is unavailable. In
either case, contact Technical Support for further instructions.
NOTE: If the LEDs light up in an on/off pattern moving from left to right this indicates that your SIM is PIN Locked; please see the 4.3.1 PIN Lock Off section for instructions
on how to x this.
