YML-O-3G19W 3G WiFi Router User Guide
www.netcomm.com.au 11
NETCOMM LIBERTY™ SERIES - 3G WiFi Router
6. Click OK and then OK again to save these settings.
The IP Address will be automatically assigned from the Router.
STATIC Mode:
If you do not wish to use automatic assignment of IP Addresses and want to congure your network settings manually, your computer
must have a static IP address within the Router’s subnet.
The following steps show how to congure your computer’s IP address within the default subnet of 192.168.1.x:
NOTE: The default IP address of the router is 192.168.1.1, so the computer must be set with a different IP to the router. In the case below, the computer’s IP address is
set as 192.168.1.2
1. Click on the Start button and go to Settings, then select the control panel (or proceed directly to the control panel).
2. Double left click on the “Network Connections” control panel item.
3. Right click on the “Local Area Connection” and select “Properties”.
4. Left click on the “Internet Protocol (TCP/IP)” item and then click “Properties”.
5. Choose an IP address between 192.168.1.2 — 192.168.1.254 and enter this IP address into the IP Address eld.
6. Enter a Subnet mask of 255.255.255.0 and the IP address of the Router (the default IP is 192.168.1.1) into the Default
gateway elds.
7. Enter the IP address of the Router (the default IP is 192.168.1.1) into the Primary DNS eld.
8. Click OK and then OK again to save these settings.
Windows Vista/7:
DHCP Mode:
1. Click on the Start button and go to the control panel.
2. Click on “Network and Internet” and then click on “Network and Sharing Centre”.(For Windows Vista)
3. Left click on “Manage Network Connections” from the menu on the left hand side of the window.(For Windows 7)
4. Left click on “Change adapter settings” from the menu on the left hand side of the window.
5. Right click on the “Local Area Connection” item and left click on “Properties”.
6. Left click on “Internet Protocol Version 4 (TCP/IPv4)” and click “Properties”.
7. Make sure “Obtain IP Address automatically” and “Obtain DNS server address automatically” are selected.
