Prints fall behind the machine when they
are output.
Raise the appropriate stop fence (forward fence for A4/Letter, rear
fence for Legal size prints). See
Exterior: Rear View .
Prints do not stack properly.
● Paper is damp. Use paper that has been stored properly. See
Paper and Other Media .
● Select [Mode2] or [Mode3] in [High Humidity Mode] under
[Machine Settings]. Note that if you select [Mode2] or [Mode3],
the first print takes longer than subsequent prints to complete.
● Raise the appropriate stop fence (forward fence for A4/Letter,
rear fence for Legal size prints). See
Exterior: Rear View .
The whole printout is blurred.
● Paper is damp. Use paper that has been stored properly. See
Paper and Other Media .
● Select [Mode1], [Mode2] or [Mode3] in [High Humidity Mode]
under [Machine Settings]. Note that if you select [Mode2] or
[Mode3], the first print takes longer than subsequent prints to
complete.
● If you enable [Toner Saver Mode] under [Machine Settings],
printing is generally less dense.
● Toner is almost depleted. If “Near End X Toner” (“X” indicates
the toner color) appears on the screen, replace the indicated
print cartridge.
● Condensation may have collected. If rapid change in
temperature or humidity occurs, use this machine only after it
has acclimatized.
The toner is powdery and comes away
from the paper, or the printed image has
a matt appearance.
Check if the fusing unit lever is lowered or the grey knobs are
positioned as in the image below.
See Using the Machine Again After It Has Been Inactive for a Long
Period .
Related topics
Changing the Printer Driver Settings
Printed Colors Do Not Match Displayed Colors
Print Positions Do Not Match Display Positions
Top Previous Next
Copyright © 2009
