display.
Within 30 seconds, place the original back side down and top to the machine rear on the
exposure glass, and then press the [B&W Start] key or [Color Start] key again.
Use the same mode (color or black-and-white) for both sides.
● Use the following keys to cancel settings:
❍ [ ]: Cancels the changes made to settings and returns the display to the previous screen.
❍ [Clear/Stop]: Cancels the changes made to settings and returns the display to the initial screen.
● If you do not copy the back side within 30 seconds after copying the front side, the job will be canceled.
● Regardless of the machine's reduction or enlargement ratio setting, an ID card copy will always be made at 100%.
● You can change the machine's default [Reduce/Enlarge] setting to always make photocopies in ID card copy mode.
● Setting this function for the current job temporarily disables the [Duplex Copy] setting automatically. However, after the
temporary job setting is cleared, the duplex copy function will be enabled again automatically.
● Temporary job settings are cleared in the following cases:
❍ When no input is received for the period of time specified in [Auto Clear] while the initial screen is displayed.
❍ When the [Clear/Stop] key is pressed while the initial screen is displayed.
❍ When the machine's mode is changed.
❍ When the power is turned off.
● For details about [Reduce/Enlarge], see Copy Settings .
● For details about [Auto Clear], see Administrator Settings .
Top Previous Next
Copyright © 2009
