EQQW028E EQQW032E
EQQW028E JOB COMPLETION CHECKER INITIALIZATION FAILED
Explanation: The JCC could not acquire all resources required for normal operation. The most likely cause of this
error is that the JCC message library could not be opened or that the library is incorrectly defined. It is also possible
that there was an error in the JCCOPTS statement.
System action: JCC processing is terminated. Message EQQZ045W is issued.
Problem determination: Review earlier messages in the TME 10 OPC message log to determine the exact reason
for this message.
System programmer response: Correct all errors and then restart the JCC.
EQQW029E JCC FOUND INVALID NUMERICS BETWEEN COLUMNS
BCOL
AND
ECOL
IN MEMBER
MEMBER
IN
THE EQQJCLIB MESSAGE TABLE FILE. INCORRECT RECORD FOLLOWS:
MSGREC
Explanation: A message table record contains invalid information and cannot be used.
System action: JCC will not use the incorrect message library member. If the member name is EQQGJCCT,
message EQQW063E is issued. In all other cases, the JCC continues processing.
System programmer response: Correct the message table definition error and replace member
MEMBER
in the
EQQJCLIB message table dataset.
EQQW030I A DISK DATA SET WILL BE FORMATTED, DDNAME =
DDNAME
Explanation: TME 10 OPC has started to format an event dataset or a submit/release dataset for the ddname
DDNAME
.
System action: TME 10 OPC processing continues.
User response: None.
EQQW031E JCC ALLOCATION OF A SYSOUT DATA SET FAILED FOR
JOBNAME
(
JOBNUM
) DYNAMIC
ALLOCATION ERROR CODE:
RETC
, INFORMATION REASON CODE:
RSNC
Explanation: The JCC could not allocate a SYSOUT dataset for the job
JOBNAME
(
JOBNUM
). The dynamic
allocation error and information reason codes are given in hexadecimal.
System action: An incident record is written to the JCC incident log and the job is flagged as having encountered a
JCC error. The JCC stops processing the current job.
Problem determination: Use the DYNALLOC return code and reason code to determine the cause of the error. For
more information, refer to the appropriate DYNALLOC documentation for the currently active MVS/ESA system.
Operator response: Check that the correct status is set for the job. If necessary, set the status manually.
System programmer response: Look up the meaning of the dynamic allocation error and information reason codes,
and take appropriate action.
EQQW032E THE JOB COMPLETION CHECKER LIBRARY, DDNAME EQQJCLIB, COULD NOT BE OPENED
Explanation: The JCC could not open a required input dataset, ddname EQQJCLIB.
System action: JCC processing is terminated. Message EQQW028E is issued.
Problem determination: Check that EQQJCLIB is correctly defined and that the TME 10 OPC started task is
authorized to open the dataset.
System programmer response: If necessary, restart the JCC.
300 TME 10 OPC Messages and Codes
