102
Specify a New Boot Image Through the CLI
1. Find the name of your new system image by listing all the image files on the Topspin chassis. Enter
the dir image command.
2. Copy the displayed system-image (this will be pasted into the boot-config command).
3. Specify the new boot image.
Enter boot-config
primary-image-source
,
then paste the
then paste the copied
image
file
name.
Syntax:
Example
4. Show the new system -image.
Example
Reboot the System
The complete reboot process is described in the other chapters.
• Reboot the system through the GUI (refer to page 37).
• Reboot the system through the CLI (refer to page 43).
Topspin-360# dir image
=========================================================================
Existing Boot-Images on System
=========================================================================
slot date-created size file-name
-------------------------------------------------------------------------
1 Tue Feb 25 16:14:15 2003 23198989 TopspinOS-2.0-build491
1 Thu Jan 1 00:18:52 1970 1024 TopspinOS-2.0/build491
1 Tue Feb 25 16:17:04 2003 1024 TopspinOS-2.0/build497
Topspin-360#
boot-config primary-image-source image-directory-name
Topspin-360# configure
Topspin-360(config)# boot-config primary-image-source
TopspinOS-1.1.3/build497
Topspin-360(config)# exit
Topspin-360# show boot-config
=========================================================================
System Boot Configuration
=========================================================================
slot-id : 1
sw-version : TopspinOS-1.1.3/build491
last-image-source : TopspinOS-1.1.3/build491
primary-image-source : TopspinOS-1.1.3/build497
