Menu 2-15
◆ Print Media Skew Lines — prints a swath of parallel lines
across the width of the media, in alternating directions, con-
tinuously until you stop the print. If the swaths are not paral-
lel to each other, the media is skewed (not feeding straight).
If there is a noticeable space between swaths, or if they over-
lap, the media advance should be calibrated (see “Media
Feed” on page 4-9 for instructions).
◆ Fill Service Station — fills the service station reservoir with
cleaning solvent.
◆ Reset Reservoir Filters — after you replace the reservoir fil-
ters, select this option to reset the ink counts to zero. See
“Replace Ink Filters” on page 5-18 for instructions.
◆ Respool Media — this option enables you to respool media
from the supply directly to the takeup (in either direction)
without passing over the heaters or platen.
◆ Clean Grit Rollers — advances the grit rollers continuously so
they can be cleaned (with no media loaded).
◆ Capping Purge — enables you to disable or enable the purge
that is automatically performed prior to capping.
◆ Printheads Procedures — see “Printhead Maintenance” on
page 5-7, for instructions on using the following options:
◆ Cleaning Solvent Soak
◆ Prep for Storage/Shipping
◆ Load Ink in All Heads — when installing ink for the first
time, or when restarting the printer after an extended
power down period, this function fills the empty print-
heads with cleaning solvent, empties the printheads, and
fills the heads with ink.
◆ Fill Heads with Solvent — fills the printheads with clean-
ing solvent.
◆ Fill Heads with Ink — fills the printheads with ink.
◆ Empty Heads (Fill With Air) — fills the printheads with
air.
◆ Cyan Heads Maintenance — performs two purges, then
fills the heads with cleaning solvent four times, then
empties the heads, and then fills them with ink again.
Perform every time the printer is idle for 24 hours, to
keep the cyan printheads working. Follow up with the
procedure “Checking Jet Health” on page 3-6 to keep all
jets working.
