Menu 2-11
◆ Supply Out Detection — for roll-fed media, the printer usu-
ally monitors the supply spool to detect when it runs out of
media. You can use this menu option to disable media out
detection when you keep the takeup spool pin release tool
(part number 0504334, see “Takeup Spool Pin Release” on
page 3-22 for instructions) installed for printing rather than
to freely pull a small amount of media from the supply.
MEDIA WIZARD ◆ Heater Temp Settings — selects one of several pre-defined
temperatures, plus one custom, user-defined setting. Exces-
sively high heat could cause the media to deform or stick to
the platen, while not enough heat could result in partially
dried prints. For instructions, see “Setting Heater Tempera-
tures” on page 3-34.
MEDIA WIZARD ◆ Platen Vacuum Control — turns on the vacuum fans, then
allows you to raise or lower the fan speed. Raise the speed if
the media is rising off the platen, lower the speed if the
media is buckling or wrinkling. Turn off the vacuum for light-
weight media such as paper or fabrics.
MEDIA WIZARD ◆ Drying Delay — a drying delay slows throughput (media
advance speed) to allow prints to dry more thoroughly.
Select the shortest delay that permits complete drying.
◆ Excess Ink Sensor — enables you to disable the excess ink
sensor if it is malfunctioning, or enable it after it has been
replaced. When the sensor in the excess ink reservoir under
the supply reservoirs indicates that the reservoir is full, it
generates an Action message on the control panel, and print-
ing cannot proceed. Do not disable the sensor unless a mal-
function erroneously prevents printing.
◆ Capping Station Sensor — allows you to disable the cap-
ping station sensor if it is malfunctioning, or enable it after it
has been replaced.
◆ Media Out Sensor (72SR) — allows you to disable the input
table’s media out sensor if it is malfunctioning, or enable it
after it has been replaced. Use care when printing with this
sensor disabled, to avoid printing on the platen or striking
the carriage against the media.
◆ Gutter Settings — determines the appearance of the top and
side gutters:
◆ Top Gutters — allows you to turn On or Off the gutter
pattern at the top edge of the print, which shows data
