FOX 500 DA6 • Remote Control
Remote Control, cont’d
3-12
FOX 500 DA6 • Remote Control
3-13
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Audio mute
Mute the audio 1Z
Amt1
]
Silence the receiver's audio output.
Unmute the audio 0Z
Amt0
]
The receiver outputs audio.
Show mute status Z
X!]
Auto memory
Disable auto memory 55*0#
Img0
]
Enable auto memory 55*1#
Img1
]
Show auto memory status 55#
X!]
Auto image
Trigger auto image 55*2#
Img
]
Front panel lock (Executive mode)
Lock the front panel 1X
Exe1
]
Unlock the front panel 0X
Exe0
]
Show the panel lock status X
X!]
Command/response table for SIS commands (continued)
Command/response table for SIS commands (continued)
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Test pattern
N
You must have a video input connected and fiber cable Optical 1 connected between the DA and receiver for the receiver to output a selected
test pattern.
The test pattern turns off if the input signal rate is changed or disconnected or if power is removed.
Output Color Bars 1J
Tst1
]
Set the receiver to output the Color Bars test pattern.
Output grayscale 2J
Tst2
]
Set the receiver to output the grayscale test pattern.
Output alt. pixels 3J
Tst3
]
Set the receiver to output the alternating pixels test
pattern.
Test pattern off 0J
Tst0
]
Set the receiver to output the input video (no test pattern
selected).
Show test pattern status J
X1$]
