Applying Filters to Spatial Queries | 45
4 On the Data Sources tab, click the Advanced Settings button. The
Advanced Settings dialog box is displayed, as shown in the following illus-
tration.
5 Select the Apply Clipping Adjustment To The Autodesk MapGuide Spatial
Filter check box. When you select this option, Adjustment is available.
Note The unit of measure (FOOT, MILE, and so on) of the spatial filter extents
is shown next to the Adjustment text box, where you enter the number of
units you are adjusting. The Adjustment value defaults to zero (0).
6 In Adjustment, enter a positive number to replace the 0 value (1 or 2, for
example) if you want to increase the size of the spatial filter’s extents, or
enter a negative number (-1 or -2, for example) if you want to decrease the
size of the filter’s extents.
The following illustration shows an adjusted spatial filter entry:
