Filter
Top Products
Maintena nce
24
P5205 Instruction Manual
Removing the Compensation Box Covers
To open the compensation box, follow t hese steps:
1. Press the optional release tool pins into the compensation box
cover catches and gently lift the cover off a small distance. Refer
to Figure 9, below.
2. Hold the open edge apart, and use the tool to open the other side
of the compensation box.
3. With both sides of the box open, gently separate the two halves of
the compensat ion box.
Cover
catches
Figure 9: Removing the compensation box covers
Replacing the Compensation Box Covers
To replace the covers, follow these steps:
1. Align the TEKPROBE interface and the strain relief notches with
the tabs on the cover. Refer to Figure 10 on page 25.
2. Press the catches of the bottom cover in and lower the top cover.
3. Slide the tab into the notch.
4. Firmly press the pieces together until the cover catches snap into
place.