Filter
Top Products
35
930486 Rev.A
34
930486 Rev.A
IX. SET-UP, ADJUSTMENT & USE
L. FOLDING BACKREST (SEAT
FRAME ONLY) (OPTIONAL)
Quickie S-525 wheelchairs are shipped
with backrest in folded position.
1. Upright Positioning
a) Lift backrest to upright position so
that latches (A) lock into place.
b) Backrest is ready for use.
2. Folding Backrest
a) Lift and turn backrest latch handles
(B) outward.
b) Fold backrest forward.
CAUTION: Backrest latches must
be locked into place before operating
wheelchair.
M.SEAT DEPTH (SEAT FRAME
AND CONTOUR SEATS ONLY)
The seat depth can be adjusted in one
inch increments.
1. Seat Frame Depth Adjustment
a) To adjust, remove the two bolts (A)
from each side of the backrest pivot
plate.
b) Reposition the backrest to the desired
position.
c) Replace and retighten bolts on each
side of the backrest pivot plate.
2. Contour Seat Depth Adjustment
a) Remove bolts (B) on the seat hingeplate.
b) Adjust the set back to desired position.
c) Refasten bolts (B) in appropriate loca-
tion.
A
B
B
IX. SET UP, ADJUSTMENT & USE
K. BACKREST
A backrest angle-adjustment is standard
on the Contour seat, the Highback
Contour seat, and the Seat Frame.
1. Seat Depth and Angle Adjustment
on Seat Frame
a) Remove the front securing bolt (C) on
the side of the backrest hinge plate.
b) Loosen the lower rear bolt (D)
c) Set at desired angle.There are four
holes (in 4º increments) to choose from.
d) Reinstall the front bolt (C) and
tighten both bolts securely.
2. Seat Depth and Angle Adjustment
on the Contour Seat
a) The contour seat is shipped with a
seat-to-back angle of 100º and a back
height of 18"
b) To increase the seat-to-back angle,
adjust stop bolt (E) to desired loca-
tion. Do the same for the other hinge.
c) To decrease the back height, remove hinge
bolt from hole (F) and replace bolt in hole
(G). Do the same for the other hinge.
Note: Adjusting the back height will change
the seat-to-back angle. Follow instructions to
adjust the seat-to-back angle accordingly.
Note: Adjustment on both sides of the wheel-
chair must be equal.
3. Adjustment for the Highback
Contour Seat
a) Pull lever (H) upwards.
b) Lean back to desired position.
c) Release lever (H).
CAUTION:Backrest latches must be
locked into place before operating
wheelchair.
E
F
G
H
C
D
A
B