Filter
Top Products
29
930486 Rev.A
28
930486 Rev.A
IX. SET UP, ADJUSTMENT & USE
A. BATTERY REMOVAL
To remove the batteries for transporting
or servicing:
1. Remove Battery Box
a) Turn both swedge latches up (fig1&2,A)
located on the rear of the battery box.
b) Slide the box lid rearward until it is
removed.
c) Disconnect Power harness (fig 3), by
pulling plug rearward.
d) Grab handle (fig1, B) and pull entire
batter box away from chair.
e) Disconnect each battery and remove
from batterybox as needed.
2. Battery Installation
See section XI. Batteries, D for instruc-
tions and wiring diagram.
Batteries may weigh up to 40 lbs. Care
must be taken to avoid injury when
lifting.
B. SWING-AWAY FOOTRESTS
1. Installation
a) Place swing-away pivot pin (A) into
the locating hole (B) on top of the hang-
er mount with the footrest facing out-
ward from frame.
b) Rotate the footrest inward until latch
plate locks (C) into place on locking
bolt.
2. Removal
a. To remove footrest, press quick-
release lever (E).
b. Rotate footrest outward and lift.
A
B
A
B
C
A
IX. SET-UP, ADJUSTMENT & USE
TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you will need the following tools:
• 7/16" socket wrench
• 1/2" box and open-end wrench
• 3/4" box and socket wrench
• 5/32" Allen wrench
• 3/16" Allen wrench
• Phillips screwdriver #2
• Custom axle wrench (or a 1/2" open-end wrench)
You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you
need from a hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself, Sunrise recommends that you
use a torque wrench.
Note:The wrench must measure inch-pounds.You can buy a torque wrench and proper
sockets from a hardware store.
CHECK-OUT
Be sure this chair performs to your chosen operational settings. If it does not,
turn the chair off immediately and reprogram with the Quickie QTRONIX
Programmer. If you do not own a Quickie QTRONIX Programmer have your
SUPPLIER reprogram your wheelchair as needed. Or, you can order a
Quickie QTRONIX Programming Pad for your own use, from your supplier.
Note: Repeat this procedure until the chair performs to your specifications
When properly set-up, this chair will operate smoothly. Check to see that all components
work properly. If you detect a problem, be sure to correct it before use.
Pull plug