Filter
Top Products
33
930486 Rev.A
32
930486 Rev.A
IX. SET UP, ADJUSTMENT & USE
I. ARMREST WIDTH
ADJUSTMENT (CONTOUR &
HIGH BACK CONTOUR SEATS)
The width of the armrest mounts can be
adjusted.
a) Loosen screws (A).
b) Slide armrest mounting tubes to
desired location.
c) Ensure that at least 1" of tubing lies
inward of the set screws.
d) Tighten screws (A).
J. ARMREST ANGLE
ADJUSTMENT (CONTOUR &
HIGH BACK CONTOUR SEATS)
a) Raise flip-back armrest.
b) Loosen bolt (B) and jam nut.
c) Adjust the height of the bolt to
desired height.
d) Tighten jam nut.
A
B
IX. SET-UP, ADJUSTMENT & USE
H. HEIGHT-ADJUSTABLE
ARMRESTS (OPTIONAL)
(SEAT FRAME ONLY)
1. Installation
a. Slide the outer armpost into the
receiver mounted to the wheelchair
frame.
b. The armrest will automatically lock
into place.
2. Height Adjustment
a. Rotate release lever to second stop.
b. Slide armrest pad up or down to
desired height.
c. Return lever to locked position
against armpost.
d. Push arm pad until upper armpost
locks firmly into place.
3. Removing Armrest
a. Rotate release lever to first stop and
remove the armrest.
4. Replacing Armrest
a. Slide armrest back into receiver.
b. Return release lever to locked posi-
tion against armpost.
5. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer arm-
post in the receiver:
a) Loosen the four bolts on the sides of
the receiver.
b) With the armrest in the receiver,
squeeze the receiver to achieve the
desired fit.
c) Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a) Two set screws are installed in the
outer armpost.
b) Turn the set screws in or out until the
desired fit is achieved.
Height-Adjustable
Armrest Key
1. Outer armpost
2. Standard receiver
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Outer armpost tension
adjustment set screws
8. Inner armpost
9. Receiver adjustment bolts
10.Release Lever
1
10
6
7
8
4
3
5
9
2