Filter
Top Products
31
930486 Rev.A
30
930486 Rev.A
IX. SET UP, ADJUSTMENT & USE
F. JOYSTICK SWING-AWAY
RETRACTABLE MOUNT
(OPTIONAL)
The joystick is mounted with a mechanism
which allows the control to be locked in a
forward or retracted position using magnets.
Adjustment
a. To retract joystick, push outward
on the inside of joystick.
b. Push joystick away from front of
armrest until it locks into retracted
position.
c. To return to forward position, push
joystick forward until it locks into
place.
G. DUAL-POST HEIGHT-
ADJUSTABLE ARMRESTS
The dual-post flip-back armrest can be
used as either a flip-back armrest or a
removable armrest.
1. Installing Armrest
a. Insert front and rear posts
into armrest receivers.
b. Engage levers (A and B) to secure
armrest.
2. Set-up for Flip-back Operation
a. Disengage lever (A) so front post
is able to come free.
b. Armrest now has the ability to be
flipped back without removal.
3. Set-up for Removal
a. Disengage levers (A and B) so front
and rear posts are able to come
free.
b. Armrest can now be easily
removed for transferring.
4. Height-Adjustment (option)
a. Release the upper securing lever
(C).
b. Set at desired height
c. Return securing lever to locked
position.
d. Move armrest up or down to allow
armrest to snap into place.
IX. SET-UP, ADJUSTMENT & USE
3. Height Adjustment
a. Remove both bolts (F) in the hanger
frame tube.
b. Reposition footrest height.
c. Re-tighten all bolts (F).
C. ELEVATING LEGREST (OPTIONAL)
1. Installation
To install or remove Elevating Legrest
(ELR) see instructions for Swing-away
Footrest installation page 29.
2. Adjustment
a) To raise legrest, lift to desired position.
Legrest will automatically lock in place.
b) To lower legrest, while seated in chair,
first lift slightly then press release
lever (F) down and lower legrest to
desired position.
D. REMOTE JOYSTICK
INSTALLATION (OPTION)
1. To Connect
a. Line up small cylindrical connector
with its receptacle on the rear of the
joystick.
b. Push in firmly.
2. To disconnect
Pull back on the retaining ring (H) of the
cylindrical connector until it disconnects from
the joystick box.
E. TO ADJUST THE HEIGHT OF
THE REMOTE JOYSTICK
a) Remove the two pan-head screws (A),
securing the angle bracket mount (B).
b) Remove the Joystick from the mount by
unfastening the two screws (C) on the
underside of the mount.
c) Position angle bracket mount such that
you achieve the desired joystick height.
Four positions are available by
relocating the mount either on the top
or bottom of the mounting bar (D)
and/or by rotation of the angle
bracket mount.
A
C
B
D
F
F
E
H
A
B
C