Filter
Top Products
30
GB
Advanced Setup
Sync Mode
Set the type of signal input at pin 13 of the HD15 (RGB/COMPONENT) IN
connector.
• “Sync Mode” is available only when analog RGB signal is input to HD15
connector.
• There are some inputs for which only “H/Comp” can be selected. In this case,
input horizontal/vertical synchronization signals through the pin 13 or 14 of the
connectors.
• This display does not support the three value sync format of 576/60p.
• When “Video” is selected in “Sync Mode”, you can only set the 575/50i and 480/
60i signals.
H/Comp
Sets a horizontal synchronous signal input.
Video
Sets a video signal input.
RGB/YUV
Sets the type of signal for a piece of video equipment or PC connected to the HD15
(RGB/COMPONENT) connector of the display.
Auto
Automatically sets whether an analog RGB signal or a component signal is input
from a connected device.
RGB
Set when an analog RGB signal is input from a connected device.
YUV
Set when a component signal is input from a connected device.
Color System
Select “NTSC” or “PAL” to set the color system. Select “Auto” to set the color
system automatically.
“Color System” is available when the input signal is from a VIDEO IN connector
(Composite video signal).
RGB Signal
Set whether a 1280 × 720/60, 720 × 480/60 or 1920 × 1080/60 RGB input signal is
displayed as a PC signal or a video signal.
Select “HD15”, “DVI” or “HDMI” according to the input connector, and then
select “PC” or “Video” for each. The following input connectors are valid for each
setting “HD15”, “DVI” or “HDMI”.
“HD15”: HD15 (RGB/COMPONENT) IN connector
“DVI”: DVI IN connector
“HDMI”: HDMI IN connector
HD15/DVI/HDMI
Screen Saver
This is a setting to prevent or reduce screen burn or after-image that can occur by
long periods of screen display of the same image.
Off
Disables the “Screen Saver” setting.
All White
Displays an all-white screen. (Stops automatically after about 30 minutes and the
display enters standby mode.)
Sweep
Scrolls a white bar over the screen.
Standby
Turns on a screensaver for the time set in “Timer Setting” in standby (page 10).
(The display is blank during screensaver operation.) When the set time has passed,
the display returns to the regular standby state.
Menu Position
(FWD-55B2/46B2/42B2)
Changes the menu screen's orientation to match the display's installation
orientation.
Landscape
Show the menu screen horizontally.
Portrait
Show the menu screen vertically.
Menu Function and operation
Notes
Note