Filter
Top Products
S3C8245/P8245/C8249/P8249 BASIC TIMER
10-1
10 BASIC TIMER
OVERVIEW
S3C8245/C8249 has an 8-bit basic timer .
BASIC TIMER (BT)
You can use the basic timer (BT) in two different ways:
— As a watchdog timer to provide an automatic reset mechanism in the event of a system malfunction, or
— To signal the end of the required oscillation stabilization interval after a reset or a Stop mode release.
The functional components of the basic timer block are:
— Clock frequency divider (fxx divided by 4096, 1024, 128, or 16) with multiplexer
— 8-bit basic timer counter, BTCNT (set 1, Bank 0, FDH, read-only)
— Basic timer control register, BTCON (set 1, D3H, read/write)
BASIC TIMER CONTROL REGISTER (BTCON)
The basic timer control register, BTCON, is used to select the input clock frequency, to clear the basic timer counter
and frequency dividers, and to enable or disable the watchdog timer function. It is located in set 1, address D3H, and
is read/write addressable using Register addressing mode.
A reset clears BTCON to "00H". This enables the watchdog function and selects a basic timer clock frequency of
fxx/4096. To disable the watchdog function, you must write the signature code "1010B" to the basic timer register
control bits BTCON.7–BTCON.4.
The 8-bit basic timer counter, BTCNT (set 1, bank 0, FDH), can be cleared at any time during the normal operation
by writing a "1" to BTCON.1. To clear the frequency dividers, write a "1" to BTCON.0.