Support User Manuals

RayTek 54301 Thermometer User Manual

Open as PDF

of 93

Installation

5.2.2CablePreparations

Youneedtoconnectthepower supply(12to24VDC)andthesignal

outputwires.Useonlycablewithoutsidediameterfrom4to6mm

(0.16to0.24in),AWG24.

Thecablemustincludeshieldedwires.Itshouldnotbe

usedasastrainrelief!



1. Cutabout40mm(1.5in)ofthecablesheath(7)fromtheend

ofthecable.Caution:Donotcutintotheshield!

2. Cuttheshield(5)soabout5mm(0.2in)remainsexposed

from under the cable sheath (7). Separate the shield and

spread the

strands out. Shorten the inside insulation until

youcanseparatethewires(6).

3. Strip3mm(0.15in)ofinsulationfromthewires(6).



Figure5:CablePreparation

4. OpentheelectronicboxbyremovingthefourPhillipshead

screws and pulling off the lid. Unscrew the cap (1), and

removetheplasticcompressionfitting(2),therubberwasher

(3),whichisinsidethefitting,andthetwometalwashers(4).

16 MID

previous next