Filter
Top Products
Jazzy 1122 www.pridemobility.com 27
V. COMFORT ADJUSTMENTS
Anti-Tip Wheel Adjustment
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels
are preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it may
be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if either
of the following occur:
! When coming to a stop, your power chair tips forward excessively.
! The anti-tip wheels constantly rub the ground.
NOTE
:
Each drive tire must have at least 35 psi (2.4 bar) of air pressure in order for the anti-tip wheels
to be properly adjusted.
To adjust the anti-tip wheels:
1. Place a wrench on the inner locknut of the anti-tip bracket located right after the shock strut. See figure 22.
2. Turn the locknut counterclockwise to loosen.
3. Place your wrench on the adjustable cam located on the other side of the locknut. See figure 23.
4. To adjust the anti-tip upward, turn the cam counterclockwise. To adjust the anti-tip downward, turn the cam
clockwise.
WARNING! Consult your authorized Pride Provider before attempting to change the anti-tip
height! Changing the anti-tip wheel height affects handling under deceleration!
WARNING! The higher you raise the anti-tip wheels, the more tendency your power chair
has to tilt forward when coming to a stop. You can compensate for this by making a small
adjustment to the pre-programmed deceleration setting in the controller or by moving the
seat assembly farther to the rear of your power chair. Failure to do so may result in
personal injury.
PROHIBITED! Do not remove the anti-tip wheels from your power chair
Figure 22. Anti-Tip Wheel Adjustment (Inner Lock Nut)
Figure 23. Anti-Tip Wheel Adjustment (Cam)