Filter
Top Products
Jazzy 1122 www.pridemobility.com 23
V. COMFORT ADJUSTMENTS
Seatback Angle Adjustment
If your power chair is equipped with an adjustable
seatback, you can adjust it to four (4) different angles:
90°, 102°, 105°, or 107°. See figure 16.
To adjust the seatback angle:
1. Remove the seatback angle adjustment screws from
both seat hinges.
2. Set the seatback at the desired angle.
3. Reinstall the screws to both seat hinges and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of
the other.
NOTE: Changing the armrest width may increase
the overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the two setscrews located on the armrest re-
ceiver.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular
to the floor.
2. Loosen the jam nut. See figure 16.
3. Loosen the armrest angle adjustment screw. See fig-
ure 16.
4. Turn the adjustment screw clockwise to raise the front
of the armrest, or turn the adjustment screw counter-
clockwise to lower the front of the armrest.
5. Tighten the jam nut to lock the adjustment screw into
place.
Figure 16. Seatback and Armrest Adjustments
ARMREST
HEIGHT
ADJUSTING
SETSCREWS
ARMREST KNOB
JAM NUT
ARMREST
ANGLE
ADJUSTMENT
SCREW
SEATBACK
ANGLE
ADJUSTMENT
SCREW