Filter
Top Products
20 www.pridemobility.com Jazzy 1122
IV. ASSEMBLY
To install the seat:
1. Set the trapeze bars to the desired height. To change the trapeze
bar height, see V. “Comfort Adjustments.”
2. Tilt the seat back and slide the rear extrusion onto the rear
trapeze bar. See figure 10.
3. Lower the front extrusion onto the front trapeze bar until the
seat locks into place.
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch safety is
flipped down before using your power chair.
Power Seat Installation (Optional)
Your power chair may be equipped with the power seat option. While
the seat itself may be any one of the styles offered for this model, the
way the seat base attaches to the power chair power base is different.
To install the power seat:
l. Align the seat shaft to the hole in the actuator. See figure 11.
2. Insert the seat into actuator and push the seat lever forward.
3. Lock the seat into place.
4. Plug the power elevating seat switch cable into the connector on
the electronics tray.
Controller Installation
Depending on the various configurations and options you have cho-
sen for your power chair, it may have been shipped without the
controller module installed in the armrest.
WARNING! Do not place the controller cable so that
it can be pinched in the seat frame or power base
frame.
1. Flip up either the right or left armrest.
2. Loosen the setscrew on the underside of the armrest. See fig-
ure 12.
3. Slide the controller into the armrest.
4. Tighten the setscrew and lower the armrest.
5. Route the controller cable so that it cannot be pinched on the
seat hinge.
6. Slide the rear cover to expose the electronics tray.
7. Plug the controller connector into the electronics tray. See figure 6.
8. Secure the controller cable to the armrest receiver with one or
more wire ties.
Figure 12. Controller Installation
(Underside of Armrest)
SETSCREW
Figure 11. Power Seat Actuator