Filter
Top Products
PAGE 26 — C-30HD — PARTS & OPERATION MANUAL — REV. #4 (03/06/01)
Before starting the engine, refer to the HATZ diesel or
WISCONSIN air cooled engine manual for break-in
instructions.
1. IGNITION-is a push/pull type control, to start the pump
engine, the ignition control must be pulled out.
2. CHOKE-when starting the cold engine, close choke by
pulling choke control to extreme out position. Once engine is
running, push choke control all the way in.
3. STARTER-push in to start engine.
C-30HD — CONTROL PANEL
4. THROTTLE-is a variable speed type control. Turning the
throttle to the left unlocks it allowing the control to be pulled
out to the desired speed. Once the desired speed has been
reached, turning the throttle control to the right locks it in place.
Note-always unlock the throttle control before it is pushed in
because if this is not done first, possible damage could result
to the locking mechanism.
5. TAIL LIGHT-pull turns on tail light and push turns it off.
Before starting the concrete pumping procedure, let the engine
warm up a minimum of five minutes. Also thoroughly read and
understand the service manual for the C-30-HD concrete
pump and become totally familiar with its operation before
pumping.
EM26735
EM26736
EM14730
EM26789
EM20708
EM40711
EM26732
EM26733
EM26739
EM26753