Filter
Top Products
SECTION 11—TRANSPORT READY PACKAGE (TRRO)
Part No 1154294 69 TDX
®
SI, TDX SI-HD
Seating System
ƽ WARNING
This wheelchair has been tested for seating in a motor vehicle with the factory
installed seating system ONLY.
Ensurethatthefactoryinstalledseatingsystemissecuredtothewheelchairframebefore
operation.Refertotheseatingsystemowner’smanual.
Positioning Belts
ƽ WARNING
The angle of the pelvic belt should be within the preferred zone of 45 to 75 degrees
to the horizontal OR within the optional zone of 30 to 45 degrees to the horizontal.
Steeper side-view pelvic belt angles are
especially important if the pelvic belt is
intended to be used for postural support
in addition to occupant restraint in a
frontal crash. Steeper angles will reduce
the tendency for a vertical gap to
develop between the user and the belt
due to compliance of seat cushions and
belt movement, thereby reducing the
tendency for the user to slip under the
belt and for the belt to ride up on the
soft abdomen during normal use.
Steeper belt angles also reduce the tendency for upper-torso belts to pull the pelvic
belt onto the abdomen during frontal impact loading.
NOTE:Forthisprocedure,refertoFIGURE 11.4.
1. Thepelvicbeltshouldbewornlow
acrossthefrontofthepelvis.
2. Positiontheupper‐torsobelt(s)overthe
shoulders.
3. Thebelt(s)shouldnotbeheldaway
fromthebodybywheelchair
componentsorparts,includingbutnot
limitedtowheelchairarmrestsor
wheels.RefertoFIGURE 11.4for
properandimproperpositioningofthe
belts.
4. Ensurethebelt(s)arenottwisted.
5. Adjustbeltsasfirmlyaspossible,being
mindfulofusercomfort.
FIGURE 11.4 Positioning Belts
Preferred Zone
Side View
30°
45°
70°
Optional Zone
DO POSITION
BELT INSIDE
OF
ARMRESTS,
WHEELS, ETC.
DO NOT
POSITION BELT
OUTSIDE
OF
ARMRESTS,
WHEELS, ETC.