Support User Manuals

Invacare Pronto M91 Base Mobility Aid User Manual

Open as PDF

of 76

SECTION 5—WHEELCHAIR OPERATION

Pronto® M91™Base with SureStep® 42 Part No 1143153

Mode Switch

NOTE:Forthisprocedure,refertoFIGURE 5.4.

Themodeswitchisusedtoselecttheoperatingmodeforthewheelchair.Themode

switchislocatedonthejoystick.Amodeswitchisneededwheneveranyofthefollowing

operatingmodesareprogrammed:

• EnvironmentalControls(ECU1,ECU2,ECU3,ECU4)*

•3SpeedModeinDigital3Speed(Slow,Medium,Full)

•LatchedModes

•SleepMode

•RIMMode*

•RemoteDriveSelectionMode*

• Tilt/ReclineMode*

• InformationCenterDisplaySelection(doesnotrequireResetactivationatpowerup)

Ifanyoftheabovemodesareselected,thecontrolwillrequireactivationoftheswitch

immediatelyafterthepower

switchisturnedOninordertoenterthedrivemode.The

secondlineoftheLCDwilldisplay‐PRESSRESET.

*NOTE:Inthesemodes,StandbySelectallowstheresetswitchtobebypassedforusersunableto

activatetheswitch.

Memory Card Slot

Thememorycardslotisusedwiththebasicorprofessionalmemorycardforsavingor

readingwheelchairparameters.

Preparing the Joystick for Use

NOTE:Forthisprocedure,refertoFIGURE 5.9.

NOTE:Thejoystickisfactoryinstalledontherightsideofthewheelchair.Torepositionthejoystick

ontotheleftsideofthewheelchair,refertoRepositioningtheJoystick

onpage 43.

1. Turntheadjustmentlockleverto

releasetheadjustmentlockfrom

joystickmountingtube.

2. Slidejoystickmountingtubetothe

desiredposition.

3. Turntheadjustmentlockleverto

securetheadjustmentlocktothe

joystickmountingtube.

FIGURE 5.9 Preparing the Joystick for Use

NOTE:Joystick

notshown.

Joystick Mounting

Tube

Adjustment

Lock Lever

previous next