Filter
Top Products
Power Tilt Only For M71 And M91. 26 Part No.1118362 Rev A
ADJUSTING THE SEAT POSITION (FIGURE 2)
NOTE: The seat can be adjusted to three (3) positions in 1/2-inch increments.
WARNING
DO NOT attempt to adjust the seat depth. This procedure MUST be
performed by a qualified technician.
Invacare recommends using a assistant when preforming this procedure -
otherwise injury or damage may result.
1. Remove the two (2) detent pins securing the power tilt only frame to the front seat
posts as shown in DETAIL "A" of FIGURE 2.
2. Remove the four (4) mounting screws securing the two seat frame hinges to the rear
seat support assembly as shown in DETAIL "B" of FIGURE 2.
3. Tilt the seat assembly back until the power tilt only frame is clear of the front seat posts.
4. Align two (2) of the four (4) seat frame hinge mounting holes with the two (2) the rear
seat support assembly mounting holes to the desired depth adjustment according to the
chart in FIGURE 2.
5. Lower the seat assembly down onto the front seat posts.
6. Reinstall the four (4) mounting screws securing the two seat frame hinges to the rear
seat support assembly.
WARNING
Ensure the two (2) detent pins are fully engaged and the power tilt only frame
is securely locked in place before use - otherwise injury or damage may result.
7. Insert the two (2) detent pins through both the power tilt only frame and the two (2)
front seat posts as shown in DETAIL "A" of FIGURE 2.
SECTION 5
SEAT ASSEMBLY
ADJUSTING SEAT ASSEMBLY