Filter
Top Products
Part No. 1118362 Rev A 23 Power Tilt Only For M71 and M91.
CHARGING USING AN INDEPENDENT CHARGER (FIGURE 1)
NOTE: The charger port located on the FRONT of the joystick requires the use of an independent
charger.
WARNING
READ and CAREFULLY follow the individual instructions for each charger
(supplied or purchased). If charging instructions are not supplied, consult a
qualified technician for proper procedures.
CAUTION
DO NOT use an independent charger rated for over 8 amps. Otherwise,
damage may occur.
Required Items:
MODEL Battery Charger * Power Cord
M91 and M71 Supplied Supplied
* NOTE: AC power cord (3-prong plug, 15
ampere current rating; industrial type)
1. Perform one of the following:
A. Wheelchair with RII JOYSTICK:
Attach the battery charger connector to the charger port on the FRONT of the
joystick.
B. Wheelchair with "A" JOYSTICK (MKIV electronics):
Attach the battery charger connector to the charger port as shown in FIGURE 1.
2. Plug the chargers AC power cord, or extension, into the grounded 110-volt wall outlet.
3. Switch Charger ON.
4. Wait until charging is complete.
5. When charging is compleate, switch charger off and disconect from wall outlet and
wheelchair.
RII JOYSTICK
Independent
Charger Port
FIGURE 1 - CHARGING USING AN INDEPENDENT CHARGER
"A" JOYSTICK (MARK IV
ELECTRONICS)
Charger Port
SEAT ASSEMBLY SECTION 4
SEAT ASSEMBLY