Filter
Top Products
Part No. 1118362 Rev A 19 Power Tilt Only For M71 and M91.
This Procedure Includes the Following:
Operating The Power Tilt Only
Tilting The Seat Assembly
OPERATING THE POWER TILT ONLY (FIGURE 1)
WARNING
NEVER operate the wheelchair while in any tilted position over 20
o
RELA-
TIVE TO THE VERTICAL POSITION. If the drive lock-out does not stop the
wheelchair from operating in a tilt position 20
o
RELATIVE TO THE VERTI-
CAL POSITION, DO NOT operate the wheelchair. Have the wheelchair
serviced by a dealer or qualified technician.
A NOTE ABOUT DRIVE LOCK-OUT
Drive lock-out is a feature designed to prevent the wheelchair from being driven after the
seating system has been tilted beyond 20
o
*. When the drive lock-out feature has been
activated, the LED on the single function toggle switch will light.
*NOTE: 20
o
of tilt can be any combination of back angle and tilt.
NOTE: The tilt range is from 0
o
to 45
o
with a 0
o
seat-to- floor angle and 5
o
to 50
o
with a 5
o
seat-to-floor
angle.
INCREASING THE TILT ANGLE
1. Make sure the wheelchair is on a level surface.
2. Push the single function toggle switch forward towards the front of the wheelchair until
the desired angle is achieved.
DECREASING THE TILT ANGLE
1. Pull the single function toggle switch back towards the rear of the wheelchair until the
desired angle is achieved.
Single Function
Toggle Switch
Tilt
FIGURE 1 - OPERATING THE TILT FUNCTION
SEAT ASSEMBLY SECTION 3
SEAT ASSEMBLY