Filter
Top Products
SECTION 9—ANTI-TIPPERS/WHEEL LOCKS
Lightweight, Standard and Heavy Duty Wheelchairs 52 Part No. 1114811
SECTION 9—ANTI-TIPPERS/WHEEL
LOCKS
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
Installing/Adjusting Anti-tippers
ƽ WARNING
Anti-tippers are specific to the different seat-to-floor angles and/or seat-to-floor
heights. Refer to the chart in this section of the manual for correct usage and
adjustment. If these requirements cannot be achieved, DO NOT use the
wheelchair. Contact a qualified technician. If changing the seat-to-floor height with
or without a change to seat-to-floor angle, the correct anti-tippers must be used to
maintain a 1½ to 2-inch ground clearance.
If so equipped, anti-tippers MUST be attached at all times. Inasmuch as the
anti-tippers are an option on this wheelchair (you may order with or without the
anti-tippers), Invacare strongly recommends ordering the anti-tippers as a
safeguard for the wheelchair user.
Anti-tippers MUST be fully engaged and release buttons fully protruding out of
adjustment holes.
ALWAYS use anti-tippers. When outdoors on wet, soft ground or on gravel
surfaces, anti tippers may not provide the same level of protection against tipover.
Extra caution must be observed when traversing such surfaces.
Ensure both anti-tippers are adjusted to the same mounting hole.
NOTE: For this procedure, refer to FIGURE 9.1 and FIGURE 9.2.
Installing Anti-Tippers
NOTE: To ensure the correct model anti-tipper is used refer to FIGURE 9.1. Measurements for
anti-tippers are approximate and are taken with extension tube in bottom hole position.
WHEELCHAIR
MODEL
SEAT-TO-FLOOR
HEIGHT IN INCHES
ANTI-TIPPER (MEASUREMENTS IN INCHES)
LENGTH HEIGHT MODEL PART NO.
SWINGAWAY 17-1/2 to 19-1/2 13-1/2 3-1/4 1360 1058836
FIXED 21 12 2-3/4 9758 1086190