Filter
Top Products
SECTION 2—SAFETY/HANDLING OF WHEELCHAIRS
Lightweight, Standard and Heavy Duty Wheelchairs 22 Part No. 1114811
The first assistant should stand on the sidewalk and turn the wheelchair so that the rear
wheels are against the curb. Turn the anti-tippers so the anti-tip wheels are pointing up.
The wheelchair should be tilted back to the balance point and, in one continuous upward
movement, the rear wheels should be pulled up and over the curb. DO NOT return the
front casters to the ground until the wheelchair has been pulled backward far enough for
the front casters to clear the edge of the curb.
ƽ WARNING
When lowering the front casters of the wheelchair, DO NOT let the wheelchair
drop the last few inches to the ground. This could result in injury to the occupant
and/or damage to the wheelchair.
Roll the wheelchair backward and slowly lower the wheelchair in one continuous
movement. Turn the anti-tippers so the anti-tip wheels are facing down.
Stairways
ƽ WARNING
ALWAYS wear your seat positioning strap. Inasmuch as the seat positioning strap is
an option on this wheelchair (you may order with or without the seat positioning
strap), Invacare strongly recommends ordering the seat positioning strap as an
additional safeguard for the wheelchair user. The seat positioning strap is a
positioning belt only. It is not designed for use as a safety device withstanding high
stress loads such as auto or aircraft safety belts. If signs of wear appear, belt MUST
be replaced immediately.
DO NOT attempt to lift a wheelchair by lifting on any removable (detachable)
parts. Lifting by means of any removable (detachable) parts of the wheelchair may
result in injury to the user or damage to the wheelchair.
ALWAYS check hand grips for looseness before using the wheelchair. If loose
and/or worn, replace immediately.
Extreme caution is advised when it is necessary to move an occupied wheelchair up
or down the stairs. Invacare recommends that, if possible, the user be removed
from the wheelchair prior to moving. Invacare recommends using two assistants
and making thorough preparations. Make sure to use only secure, non-detachable
parts for hand-held supports.
NOTE: For this procedure, refer to FIGURE 2.5 on page 23.