Filter
Top Products
Part No. 1119240 19 INVACARE MX
Section 6 - Rear Wheels includes the following:
Removing/Installing the Rear Wheels
REMOVING/INSTALLING THE REAR WHEELS (FIGURE 1)
WARNING
If a change in the SEAT-TO-FLOOR HEIGHT is desired, this procedure
MUST be performed by a qualified technician.
Make sure both rear wheels are the same size and are installed into the
same respective mounting hole BEFORE using the wheelchair, otherwise
injury may occur.
1. Remove the dust cap, hex screw, washer, spacer and locknut that secure the rear
wheel to the wheelchair frame.
2. Repeat STEP 1 for the opposite rear wheel.
3. To reinstall the rear wheel(s) onto the wheelchair, reverse STEPS 1-2. Torque down
locknut to 40 FT-LBS.
4. Adjust wheel locks. Refer to WHEEL LOCK ADJUSTMENT in SECTION 8 of this
manual.
SEAT AND BACK
REAR WHEELS SECTION 6
REAR WHEELS
Dust Cap
Hex Screw
Rear Wheel
Axle Mounting Hole
Wheelchair Frame
Spacer
Locknut
FIGURE 1 - REMOVING/INSTALLING THE REAR WHEELS