Filter
Top Products
Part No. 1119240 15 INVACARE MX
Section 3 - Front Riggings includes the following:
Installing/Removing the Footrest
Footrest Height Adjustment
Raising/Lowering the Elevated Legrest Assembly
INSTALLING/REMOVING THE FRONT RIGGINGS
(FIGURE 1)
NOTE: This procedure applies to the swingaway front riggings and the elevating front riggings.
INSTALLING
1. Turn the front rigging to the side (open footplate is perpendicular to wheelchair).
2. Install the front rigging hinge plates onto the hinge pins on the wheelchair frame.
3. Push the front rigging towards the inside
of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat STEPS 1 - 3 for the opposite side
of wheelchair.
5. To release the front rigging, push the
footrest release lever inward, rotate
footrest outward.
REMOVING
1. Push the rigging release lever inward and
rotate the front rigging outward.
2. Lift up on front rigging and remove from
wheelchair.
3. Repeat STEPS 1-2 for the opposite side of the wheelchair.
FOOTREST HEIGHT ADJUSTMENT (FIGURE 2)
NOTE: This procedure applies to the swingaway footrest and
elevating legrest.
1. Loosen, but do not remove the bolt and locknut
that secure the lower footrest assembly to the
upper footrest support.
2. Reposition the lower footrest assembly to the
desired height.
3. Securely tighten lug bolt and locknut that secure
the lower footrest to the footrest support.
4. Repeat STEP 1-3 for the opposite side of
wheelchair, if necessary
FIGURE 2 - FOOTREST HEIGHT
ADJUSTMENT
FRONT RIGGINGS
FRONT RIGGINGS
SECTION 3
FRONT RIGGINGS
Bolt and Locknut
Lower
Footrest
Footrest
Support
FIGURE 1 - INSTALLING/
REMOVING THE FRONT
RIGGINGS
Swingaway
Footrest
Assembly
Footplate
Hinge Pins
Front Rigging
Hinge Plates
Front Rigging
Release
Lever