Filter
Top Products
A-4 64 Part No. 1110545
ADJUSTING T-ARM SOCKETS (FIGURE 6)
NOTE: Perform this procedure if the T-arm is
too loose in the socket or does not easily slide
up and down in the socket.
1. Remove the rear wheels from the
wheelchair, if necessary. Refer to
REMOVING/INSTALLING REAR
WHEELS in SECTION 5 of this
manual.
2. Loosen, but do not remove the four
(4) socket screws and washers that
secure outer T-arm bracket to the
inner T- arm bracket.
NOTE: The T-arm socket will disassemble if the
four (4) hex screws and washers are removed.
3. Slide the T-arm into the T-arm socket
until the locking lever is in the slot in the T-arm socket and an audible "click" is
heard.
4. Squeeze the outer T-arm bracket and the inner T-arm bracket together until the
socket is flush with the T-arm.
5. While holding the outer and the inner T-arm brackets together, tighten the four (4)
socket screws and washers. Tighten securely.
6. Press in on the locking lever and lift the T-arm straight up and out of the T-arm
socket.
7. Repeat STEPS 3-6, if necessary until the T-arm slides in the T-arm socket as desired.
8. If necessary, install rear wheels. Refer to REMOVING/INSTALLING REAR WHEELS
in SECTION 5 of this manual.
SECTION 8 ARMS
ARMS
FIGURE 6 - ADJUSTING T-ARM
SOCKETS
Hex Screws and
Washers
T-Arm
Socket Screws
and Washers
Inner T-Arm
Bracket
Locking Lever
Slot
Outer T-Arm
Bracket