Filter
Top Products
A-4 30 Part No. 1110545
GENERAL GUIDELINES
OPENING/CLOSING CAMBER CLAMPS (FIGURE 5)
WARNING
QUICK RELEASE LEVERS - Make sure the quick release levers are in the
CLOSED position BEFORE using the wheelchair, otherwise personal
injury or damage to the wheelchair may result.
STANDARD CAMBER CLAMPS - Make sure the hex screws are securely
tightened BEFORE using the wheelchair, otherwise personal injury or
damage to the wheelchair may result.
CAUTION
DO NOT close the quick-release levers or tighten the socket screws
without camber inserts in the axle tube. Damage to the axle tube will
occur.
1. Perform one (1) of the following to open a camber clamp:
A. QUICK RELEASE LEVERS - Pull the quick release lever to the open
position.
B. STANDARD CAMBER CLAMPS - Loosen, but do not remove the socket
screw on the camber clamp.
2. Perform one (1) of the following to close a camber clamp:
A. QUICK RELEASE LEVERS - Secure the quick release lever to the camber
clamp by threading it completely into the camber clamp. Push the quick release
lever on the camber clamps to the closed position.
B. STANDARD CAMBER CLAMPS - Securely tighten the socket screw to
secure the axle tube.
Closed Position
Open Position
Quick
Release
Lever
Camber Clamp
Socket Screw
STANDARD QUICK RELEASE
Camber
Clamp
FIGURE 5 - OPENING/CLOSING CAMBER CLAMPS
SECTION 4 FRAME
FRAME