Filter
Top Products
Part No. 1110545 21 A-4
SECTION 3UPHOLSTERY
UPHOLSTERY
Back Upholstery
Fastening
Flap
Fastening
Flap
Back
Canes
FIGURE 2 - REMOVING/INSTALLING STANDARD BACK UPHOLSTERY
Fold
Loops
Fastening
Strips
REAR OF WHEELCHAIR
FRONT OF WHEELCHAIR
REMOVING/INSTALLING STANDARD BACK
UPHOLSTERY (FIGURE 2)
WARNING
The position of the footrest, seat angle, back angle, seating system/
upholstery, caster size and position, rear wheel size and position, use of
anti-tippers, as well as the user condition directly relate to the stability of
the wheelchair. Any change to one (1) or any combination of the ten (10)
may cause the wheelchair to decrease in stability. EXTREME care MUST
be taken when changing the stability of the wheelchair. Refer to the chart in
STABILITY in SECTION 1 of this manual.
REMOVING STANDARD BACK UPHOLSTERY
1. Unfasten the two (2) fastening flaps that secure the bottom of the existing back
upholstery to the back canes.
2. Unfold the top of the back upholstery.
3. Lift up on the existing back upholstery and remove from the wheelchair.
INSTALLING STANDARD BACK UPHOLSTERY
1. Install the new back upholstery onto the back canes.
2. Wrap the end of a fastening flap around the back cane.
3. Insert the end of the fastening flap through the loop.
4. Wrap the fastening flap around the back cane again and press firmly to secure.
5. Fold the top of the back upholstery down over the back canes towards the front of
the wheelchair.
6. Press firmly to secure the fastening strips.