Filter
Top Products
9000 Series 56 Part No. 1056953
OPTIONSSECTION 10
OPTIONS
INSTALLING THE AMPUTEE BRACKET - SUPER HEMI
MODELS ONLY (FIGURE 4)
1. Remove the plug button or anti-tipper
from the step tube of the wheelchair
frame.
2. Slide the amputee attachment over the
step tube of the wheelchair.
3. Secure the amputee attachment to the
wheelchair with the hew screw, spacer
and locknut.
4. Reinstall the plug button or anti-tipper
onto the step tube of the wheelchair
frame.
5. Repeat STEPS 1-4 for the opposite side
of the wheelchair.
6. Reposition the rear wheels. Refer to
REMOVING/INSTALLING REAR
WHEELS in SECTION 6 of this manual.
FIGURE 4 - INSTALLING THE
AMPUTEE BRACKET - SUPER
HEMI MODELS ONLY
Wheelchair
Frame
Spacer
Hex Screw
Locknut
Amputee Attachment
Step
Tube
1. Slide the clamp with the base attached over the end of the step tube of the wheelchair. Ensure
the base is towards the inside of the
wheelchair.
2. Position the base parallel to the step tube.
CAUTION
Base should be parallel to step tube to
avoid bending spokes when folding the
wheelchair.
3. Securely tighten the locknut that secures
the base to the step tube of the wheelchair.
4. Remove the upper back upholstery screw
and washer.
5. Align the strap with the back upholstery
screw mounting hole.
6. Reinstall the back upholstery screw and washer and secure the strap to the wheelchair.
7. The base cleans easily with any chrome or glass cleaner. The strap can be cleaned with mild
soap and water.
FIGURE 3 - INSTALLING THE
CRUTCH AND CANE CARRIER
Clamp
Strap
Base
Step
Tube
Locknut