Filter
Top Products
Part No. 1056953 25 9000 Series
FIGURE 3 - IMPACT GUARDS/CALF STRAP
Calf Strap
IMPACT GUARDS/CALF STRAP
(FIGURE 3)(FIGURE 3)
(FIGURE 3)(FIGURE 3)
(FIGURE 3)
1. Remove impact guard/calf strap from packaged container if not already secured to
the footrest.
2. Secure one (1) impact guard to the each footrest.
NOTE: Ensure the upper portion of the impact guard is between the two (2) horizontal supports
of the footrest.
3. Secure one (1) side of the calf strap around the each footrest (with the impact
guards attached, if present).
Footrest
SECTION 3
FRONT RIGGINGS
FRONT RIGGINGS
FOOTREST HEIGHT ADJUSTMENT (FIGURE 2)
NOTE: This procedure applies to the swingaway
footrest and elevating legrest.
1. Remove the swingaway footrest
assembly. Refer to INSTALLING/
REMOVING/USING THE FOOTREST
in this section of the manual.
NOTE: Lay the assembly on a flat surface to
simplify this procedure.
2. If installed, remove impact guards and/
or calf strap.
3. Pull the cam lock lever UP to the
UNLOCKED position.
4. Push IN the release buttons and reposition the lower footrest assembly to the
desired height.
5. Ensure that the release buttons fully protrude from holes on both sides of the upper
footrest support.
6. Rotate cam lock lever DOWN to LOCKED position.
7. If installed, replace impact guards and/or calf strap.
8. Repeat this procedure for the other footrest, if necessary.
9. Reinstall the swingaway footrest assembly. Refer to INSTALLING/REMOVING/USING
THE FOOTREST in this section of the manual.
Upper Footrest Support
Lower Footrest Assembly
Cam Lock
Lever
FIGURE 2 - FOOTREST HEIGHT
ADJUSTMENT
Release Button
Adjustment
Holes
Impact
Guard
Notch
Upper Portion of
Impact Guard
Horizontal Support
Horizontal
Support