Filter
Top Products
9000 Series 32 Part No. 1056953
SEAT AND BACKSECTION 5
REPLACING THE BACK UPHOLSTERY
SCREW ON BACK UPHOLSTERY - 9000 SL (FIGURE 2)
1. Flip swing back arms up and out of the
way. Refer to
SWING-BACK ARMS in
SECTION 4 of this manual.
2. Remove the six (6) mounting screws and
washers that secure the EXISTING back
upholstery to the back canes.
3. Cut the tie wraps that secure the EXIST-
ING back upholstery to the wheelchair
frame.
4. Securely tighten the NEW back uphol-
stery to the back canes with the six (6)
mounting screws and washers starting
with the top hole of the back cane.
5. Install two (2) NEW tie wraps through
the bottom holes of the upholstery to
the bottom of the back upholstery to the
back canes.
6. Flip swing-back arms down for use. Refer to
SWING-BACK ARMS in SECTION 5 of this
manual.
SLIP ON BACK UPHOLSTERY - 9000 XT/XDT (FIGURE 3)
1. Remove the two (2) mounting screws and
washers that secure the existing back
upholstery to the back canes.
2. Remove the two (2) mounting screws and
locknuts that secure one (1) back cane to
the wheelchair frame.
NOTE: It is necessary to remove only one (1) back
cane to replace the back upholstery.
3. Pull the loose back cane out of the
existing back upholstery.
4. Pull the existing back upholstery up and
over the mounted back cane.
5. Install the NEW back upholstery over the
mounted back cane.
6. Slide the loose back cane through the NEW back upholstery.
7. Secure the back cane to the wheelchair frame with the two (2) allen screws and locknuts.
8. Secure the NEW back upholstery to the back canes with the existing mounting screws and
washers.
FIGURE 2 - REPLACING THE
SCREW ON BACK UPHOLSTERY -
9000 SL
Mounting
Screws
Washers
Washers
Mounting Screws
Back Upholstery
Back
Cane
Tie Wraps
SEAT AND BACK
Mounting
Screws
Back Upholstery
Washer
Back Cane
NOTE: The two (2) mounting screws and lock-
nuts that secure the back cane to the wheel-
chair frame are not shown for clarity.
FIGURE 3 - REPLACING THE SLIP
ON BACK UPHOLSTERY -
9000 XT/XDT