Filter
Top Products
Part No. 1056953 53 9000 Series
INSTALLING THE TELESCOPING I.V. ROD SUPPORT TUBE
(FIGURE 14)
NOTE: The I.V. rod holder must already be mounted to the side frame of the wheelchair.
1. Insert the I.V. rod support tube into the rear cylinder of the I.V. rod holder.
NOTE: When installing the I.V. rod support tube, ensure the adjustment knob is pointing out away
from the wheelchair.
2. Turn the I.V. rod support tube until the holes in the I.V. rod support tube align with
the holes in the rear cylinder of the I.V. rod holder.
3. Insert mounting screw through rear cylinder, large nylon washer, small nylon
washer, steel washer, and into locknut. Securely tighten.
NOTE: The large nylon washer must be inserted into hole and pressed in so that it is flush with
outside surface of rear cylinder.
4. Reinstall the rear wheel from the wheelchair. Refer to REMOVING/INSTALLING
THE REAR WHEELS in this section of the manual.
5. Adjust I.V. rod to desired height. Refer to ADJUSTING THE TELESCOPING I.V.
ROD in this section of the manual.
ADJUSTING THE TELESCOPING I.V. ROD (FIGURE 14)
1. Loosen adjustment knob.
2. Adjust I.V. Rod to desired height.
3. Securely tighten adjustment knob.
FIGURE 14 - INSTALLING/ADJUSTING THE TELESCOPING I.V. ROD
SUPPORT TUBE
NOTE: Attaching hard-
ware enlarged 3X scale
for clarity.
I.V. Rod Holder
Adjustment Knob
Steel Washer
Rear Cylinder
Large Nylon Washer
Small Nylon Washer
Locknut
Mounting Screw
I.V. Rod Support Tube
I.V. Rod
SECTION 9RECLINER
RECLINER