Filter
Top Products
9000 Series 36 Part No. 1056953
REPLACING REAR WHEEL HANDRIM (FIGURE 2)
WARNING
If the wheelchair is equipped with
permanent axles, this procedure
MUST be performed by a qualified
technician.
1. Remove the rear wheel from the
wheelchair. For non-recliner models,
refer to
REMOVING/INSTALLING THE
REAR WHEELS in this section of the
manual. For 9000XT Recliner, refer to
REMOVING/INSTALLING THE REAR
WHEELS in SECTION 9 of this manual.
2. Remove the mounting screws that secure the handrim to the rear wheel.
3. Remove the existing handrim.
4. Install the NEW handrim by reversing the above procedures.
WARNING
Make sure detent pin and locking pins of the quick-release axles are fully
released BEFORE operating the wheelchair .
5. Reinstall rear wheel to the wheelchair. Refer to REMOVING/INSTALLING THE
REAR WHEELS in this section of the manual.
6. If the locking pins of the quick-release axles (if applicable) are not protruding past
the inside of the axle bushing or there is too much movement of the rear wheel
assembly in a back and forth position, refer to ADJUSTING THE QUICK-RELEASE
AXLE in this section of the manual.
7. Repeat the procedure for the opposite rear wheel if necessary.
REPLACING/REPAIRING REAR WHEEL TIRE/TUBE
WARNINGWARNING
WARNINGWARNING
WARNING
Replacement of rear wheel tire or tube MUST be performed by a quali-
fied technician.
Handrim
Mounting Screw
FIGURE 2 - REPLACING REAR
WHEEL HANDRIM
Rear
Wheel
REAR WHEELSSECTION 6
REAR WHEELS